FAST2000® Field Devices
There are a range of field devices available for the FAST2000 range.
These devices include sounders, sounder bases, beacons, callpoints & push buttons.
Sounder Roshni-LP
An electronic sounder for use in fire detection systems. The sounder consists of an impact resistant housing with sealed electronics inside. The base is designed for surface mounting and is equipped with a bayonet fixing.
230V AC Base for Sounder Roshni-LP and Beacon Solex 3/10
This base has an integrated power supply unit and can connect sounders and beacons to the mains supply. The
base is designed for external use.
Beacon Solex 10
The beacon consists of a plastic housing with red lens , integrated electronics with supervision diode and the Ubase
with an O-ring seal.
The base is prepared for 2 x cable glands M 20 x 1.5.
Manual Call Point HFM/3/22/17
The manual call point is designed according EN54-
11/B for use on a loop with System Sensor protocol.
The call point consists of a rough aluminium case
which is high resistant against environmental
influence. Also after years of use it is stable in form,
unbreakable and no change of colour when exposed
to sunlight.
The call point has an optical LED indicator for
activation. The address of the call point is set with a
button on the PCB. The indication of the address is
done with a LED. An integrated isolator on input and
output disconnects the next element in case of short
circuit.
Manual Call Point HFM/3/11/00
The manual call point is designed according EN54-11/B for use on a conventional line. The call point
consists of a rough aluminium case which is high
resistant against environmental influence. Also after
years of use it is stable in form, unbreakable and no
change of colour when exposed to sunlight.
The call point has an optical LED indicator for
activation.
Manual Release Push Button HM/1/22/17/17
The manual call point is designed according EN54-
11/B and EN12094-3 for use on a loop with System
Sensor protocol. The call point consists of a rough
aluminium case which is high resistant against
environmental influence. Also after years of use it is
stable in form, unbreakable and no change of colour
when exposed to sunlight.
The call point has an optical LED indicator for
activation. The address of the call point is set with a
button on the PCB. The indication of the address is
done with a LED. An integrated isolator on input and
output disconnects the next element in case of short
circuit.
Manual Release Push Button HM/1/11/05/00
The manual call point is designed according EN54-11/B and EN12094-3 for use on a conventional line.
The call point consists of a rough aluminium case
which is high resistant against environmental
influence. Also after years of use it is stable in form,
unbreakable and no change of colour when exposed
to sunlight.
The call point has an optical LED indicator for
activation.
Stop Push Button HM/5/11/18/17
The stop push button is designed according EN54-11/B and EN12094-3 for use on a conventional line.
The stop push button consists of a rough aluminium
case which is high resistant against environmental
influence. Also after years of use it is stable in form,
unbreakable and no change of colour when exposed
to sunlight.
The stop push button has an optical LED indicator
for activation.
|
